Toro 30381 Operator's Manual page 17

Figure 29
1. Front tire
20. Carefully lift the tracks over the rear wheel and front
hubs. The direction of the track rotation is printed
on the track. The V design in the rubber track must
point forward.
CAUTION
The track guides have many pinch points.
Carefully grasp the rubber track on the outer
edges outboard of the steel guides when moving
the track.
21. Adjust the floor jack to a suitable height to install the
front tire. With a helper, lift the front of the track
enough to carefully install the front tires (Figure 30).
Figure 30
22. Adjust the floor jack to a suitable height to install the
center tire. Lift the center of the track enough to
install the center tire. Torque the lug nuts to 65 to
85 ft-lb (88 to 115 N⋅m).
23. Lower the floor jack until the front wheels support
the frame. Install the flat washers (1/2 inch) and
locknuts on the bogie pivot stud (Figure 28) and
torque to 75 ft-lb (102 N⋅m).
Note: You may need to move the floor jack to the
rear bumper to raise the rear of the machine high
enough to install the flat washer and locknut.
24. Install the side access covers with the screws
previously removed (Figure 32).
1. Access covers
25. Install the winter frame floor plate cover to the floor
with the screws previously removed (Figure 33).
17
Figure 31
Figure 32