LifeSpan SPORTZ Owner's Manual page 18

lock well or not put well the
connector.
SENSOR do not touch well. 2.Checking the wire and
No hand
pulse
The hand pulse do not touch
well
Message failure
E01
burst clash
E02
No sensor signal
E03
Incline study failure
E04
SPORTZ
cover and press PA circuit
board to see if it is short
circuit or loosen.
1.Checking the wire is
short circuit or lossen.
computer if the tie-in is
connected well.
3.Put the both hands to
bedew a litter or scrub with
both hands.
1.the connected wire is
wrong.
2.Power supply voltage
shortage
1．Power tube badness
2．Drivers badness
3．Motor is failure
1.Sensor wire badness
2． It is no use for the motor
magnetic.
3．Drivers badness
1．Study failure
2. Incline motor badness
3．Drivers badness
4． Incline motor wire do not
connect well
- 18 -
lock the bolt.
1.Change the wire or reset.
2.Reset to insert the wire
3.Reset to test.
1.Use the multimeter to test the
wire is stand or fall.
2.To test the outside and the
ins ide voltage is normal.
（DC12V）
3.SCM is badness.
1．Change the power tube
2．Change the drivers
3．Change the motor
1．Change the sensor wire
2．Change the magnetic or
reset the magnetic
3．Change the drivers
1．To reset study
2．Change the incline motor
3．Change 24C02 or change
the drivers
4．Insert the incline motor wire.