LifeSpan SPORTZ Owner's Manual page 17

PROBLEM
1.If the plug and the line is
Treadmill
loosen.
will not
start.
2.Not plugged in.
1.The relative line of the
control motor are abnormal.
2.Do not press START KEY.
The motor
will not
3.Safety pull pin not inserted
work.
4.Motor plug is loosen or the
motor is badness.
5.Power or controller
specification is wrong. AC
（220~240）V
SENSOR does not touch
No speed
well.
PA circuit
Pa circuit board bolt do not Take apart the bottom
board
SPORTZ
TROUBLESHOOTING GUIDE
CAUSE
1. Checking the plug and
the line is connected well.
2.Checking
switch is opened.
1.Checking the line of the
control motor is plugged
well.
2.Checking the button is
valid or not started the
switch.
3.Checking the safety pull
pin is plugged well.
4.Testing if the motor is
badness.
5.Checking the
specification.
1.Checking the distance
and place between
SENSOR and magnet.
2.Checking the wire if
circuit breaker tripped.
3.Checking the wire tie-in
if it is touched well.
CHECKING
1.Insert the plug and the line
well.
the power
2.Reset the power.
1.Insert the control motor wire.
2.Reset the START KEY to
test.
3.Insert safety pull pin.
4.Change the motor
5.To choose the correct
specification to reset the
testing.
1.Adjust the distance within
5m/m.
2.Change the wire or SENSOR
3.Reset to insert the wire tie-in.
Reset to put the connector and
- 17 -
CORRECTION