Placing Child In The Restraint - Britax safe-n-sound Instructions For Installation & Use

HOW TO USE

PLACING CHILD IN THE RESTRAINT

A. Ensure the headrest and shoulder straps are adjusted to
the correct height for your child (see page 70). Release
and lengthen the shoulder straps by pressing the harness
adjuster and pulling both shoulder straps evenly. Pull out to
the lengthen. Place the two harness tongues into the Buckle
Tongue Holder.
Remove the padded insert. If your insert has removable side
wings, it may be used in forward facing mode, with the side
wings detached for increased comfort of a growing child.
Stop using if your child suffers discomfort.
B. Place child in the restraint and feed each arm through the
shoulder straps. Pull harness buckle up between child's legs.
IMPORTANT :
Always adjust the height of the shoulder straps as the child grows.
C. Fit either harness tongue into the harness buckle followed by the other tongue. A click is heard when
the last tongue is fully engaged.
Should the second tongue not engage - press the red button and reinsert the tongues. Ensure secure
engagement by pulling harness straps. If the harness buckle does not engage correctly then it may
require cleaning or seek replacement - refer to page 79. The buckle tongues are fully engaged when
both tongues are inserted and 'click' is heard.
Tongue
72
Instructions for Installation & Use
Buckle
The Flexi Infant Safety Cushion™
Insert with removable side wings.
Click
Pull to remove slack from
harness lap straps
A