Warnings - Britax safe-n-sound Instructions For Installation & Use

IMPORTANT :
• TO BE USED WITH A LAP-SASH OR LAP-ONLY SEATBELT OR ISOFIX LOW ANCHORAGES IN
THE BACK OF MOST CARS WITH FORWARD FACING SEATS.
• Do not attach the lower attachment connectors of two separate child restraints to the same
ISOFIX low anchorages in your car.
• Always attach the top tether strap to the child restraint upper anchorage in your car.
• Child restraint lower attachment connectors and the ISOFIX low anchorages in your car are designed to
withstand only those loads imposed by a correctly fitted child restraint.
• Regularly check the restraint components, straps and other fitments for correct function and condition. If
faulty, cease using and seek repair by Britax.
• IF AN AIRBAG IS FITTED IN THE SEATING POSITION WHERE THE CHILD RESTRAINT IS TO BE
FITTED, FOLLOW THE VEHICLE MANUFACTURERS WARNINGS AND INSTRUCTIONS.
• Protect all webbing from abrasion and cutting by sharp corners and edges.
• The restraint should not be purchased or sold as a second hand item. It is recommended not to use
child restraints older than 10 years as the protection in an accident may be reduced.
• Seatbelt extenders are not recommended to be used if the seatbelt is not long enough to secure the
child restraint. If seatbelts are too short then seek advice from a child restraint fitter and consider their
recommendations before using a seatbelt extender. If you use a seatbelt extender then ensure that the
seatbelt buckle does not enter the rearward or forward facing belt paths.
• THIS RESTRAINT MUST BE ATTACHED TO A CHILD RESTRAINT UPPER ANCHORAGE POINT
IN THE CAR. REFER TO CAR OWNER'S HANDBOOK FOR LOCATION OF UPPER ANCHORAGE
POINTS. REFER TO A CHILD RESTRAINT FITTING STATION IF NO UPPER ANCHORAGE POINTS
ARE IN THE MOTOR CAR. Refer to pages 88 to 91.
Instructions for Installation & Use
19