How To Install Using Isoflex Connectors - Britax safe-n-sound Instructions For Installation & Use

HOW TO INSTALL USING ISOFLEX CONNECTORS

C. Recline instructions are shown on page 60.
D. Press and hold the ISOFLEX strap adjuster button and pull
the connector strap to fully lengthen. Repeat for both connector
straps.
E. Place the restraint in the desired location on the vehicle seat
between the two ISOFIX low anchorages. Ensure the child seat
is against the vehicle seatback. Engage the ISOFLEX
connectors with each ISOFIX low anchorage. A click may
be heard and a green indicator will show on the top of the
ISOFLEX connector when it has engaged. Pull each strap
to ensure both lower anchorage connectors are engaged.
NOTE: Pull against the ISOFLEX connector to verify that
it is secure.
F. Push downwards on the side of the restraint to compress
it into the vehicle seat. Whilst pushing down in the seat,
pull on the adjuster strap to remove all slack and tighten.
Repeat for the adjuster strap on the other side of the
restraint.
The two tension indicators will show 'green' indicating
adequate tension has been applied.
G. Follow top tether installation instructions on page 66.
IMPORTANT:
Do not attach the lower attachment connectors of two separate child restraints to the same ISOFIX
low anchorages in your car.
Always attach the top tether strap to the child restraint upper anchorage in your car.
Child restraint lower attachment connectors and the ISOFIX low anchorages in your car are designed to
withstand only those loads imposed by a correctly fitted child restraint.
Instructions for Installation & Use
65