Placing Baby Into Restraint - Britax COMPAQ Instructions For Installation & Use

HOW TO USE

PLACING BABY INTO RESTRAINT

CROTCH STRAP POSITION - BABY USE
The crotch straps must be in the inner position to accommodate the
smaller child. Refer to page 23 (Care & Maintenance) instructions
and follow point A. Ensure both crotch straps are in the inner
position as shown right.
A. The harness shoulder straps should first be set to the
correct height position. Refer to page 9 for
adjusting shoulder harness strap height. The
restraint can be used with or without the
Padded Insert.
B. Ensure Upper Anchorage Strap is
attached to Anchor Fitting, then
slacken Upper Anchorage Strap
and allow to fall to the sides of
the restraint for easy access to
the baby.
C. Slacken Harness Straps by
pushing Harness Adjuster
up, grasping both
shoulder harness straps
and pulling out desired
amount of slack.
Release Harness
Adjuster lock when there is
enough slack and place
harness to each side of
restraint.
D. Lay baby on its back into restraint
and fit harness as shown above.
Make sure baby is dressed to allow
harness buckle to be pulled up between
baby's legs e.g. a jump suit. Make sure
baby's arms and legs are free.
baby in a blanket before placing in restraint.
E. Fit either harness tongue into the harness
buckle followed by the other tongue until a click
is heard. Should the second tongue not insert,
press the red button and reinsert the tongues.
Ensure secure engagement by pulling
harness straps.
Padded Insert,
if supplied, snugly
Harness
supports the baby
shoulder
for extra comfort.
straps.
Never wrap
Front of vehicle
Rearward Facing (Up to 12 kg)
Inner Crotch
Strap Position
Slackened Upper
Anchorage Strap.
Lift up
Adjuster.
(under flap)
Click
13