Table of Contents
Advertisement
WHEN USED WITH THE 'BUILT-IN' HARNESS
• Fit the restraint firmly to the car seat.
• Fit the harness firmly to the child.
• A loose restraint or harness is dangerous.
• When used in this mode the restraint must be fitted to the car with a lap or lap-sash seat belt.
AS A BOOSTER SEAT (with or without a separately supplied Child Harness)
• DO NOT USE WITH JUST A LAP BELT. You must use with a lap-sash seatbelt or with a seat belt and
child harness.
• The lap part of the seatbelt must be firmly across the thighs and the sash belt fitted diagonally across
the chest and on the shoulder.
• If used with a child harness, the lap belt must be adjusted firmly first and then the harness, so that the
lap belt is not lifted off the child's lap when the harness is adjusted.
• Do not use with the integral harness when in booster mode. This built in harness must be stored.
GENERAL WARNINGS
• Supervision of children is needed because they may be able to undo the buckles and adjusters.
• Use the restraint exactly as shown in the instructions.
• DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
• Do not alter or modify this restraint.
• Repairs must only be done by the manufacturer or agent. Use only recommended parts and
accessories.
• Do not allow the restraint to come into contact with polishes, oils, bleach and other chemicals.
• Destroy the restraint if it has been in a severe crash, even if no damage is visible.
• DO NOT USE THIS RESTRAINT WITHOUT THE COVER.
• This child restraint is not approved for use with any connectors that connect to the car's ISOFIX low
anchorages.
• Always secure the loose end of the top tether strap. Do not use the child restraint where this strap may
fall into a split in the seat back or off the side of the seat.
• Versatether top tether attachment clip is ONLY USE FOR ATTACHMENT OF CHILD HARNESS.
• Always attach hook and remove slack
12
Instructions for Installation & Use - Series No. BS8100A-020133
Advertisement
Table of Contents
