Oil Strainer; Engine Oil Pressure Regulator - BOMBARDIER Traxter 7400 Shop Manual

CAUTION: Only use Bombardier high pressure
filter or suitable equivalent. The Bombardier filter
is specifically designed for this engine. This filter
does not operate at the same pressure as other
brands. Using a non-recommended filter may
cause serious engine/transmission damage.
Lubricate the O-ring on the filter with engine oil.
Install the new filter then screw one full turn after
O-ring contact.
Wipe out any oil spillage on engine.
Change gasket on drain plug. Clean gasket area on
engine and drain plug then reinstall plug. Refill en-
gine at the proper level with the recommended oil.
Refer to TECHNICAL DATA 11-02 for capacity.
Start engine and let idle for a few minutes. Ensure
oil filter area and drain plug areas are not leaking.
Stop engine. Wait a while to allow oil to flow down
to crankcase then check oil level. Refill as neces-
sary.
Dispose oil as per your local environmental regu-
lations.

OIL STRAINER

Removal
Ensure vehicle is on a level surface.
Remove:
– skid plate under vehicle
– engine oil
– screws no. 1 retaining oil strainer cover no. 2
– oil collector no. 3 and O-ring no. 4
– oil strainer no. 5
Cleaning and Inspection
Clean oil strainer with the parts cleaner then use
an air gun to dry it.
Inspect O-ring and oil strainer gasket no. 6 for
damage. Change if necessary.
Installation
For installation, reverse the removal procedure.
VMR9959_03-08A.FM
Subsection 08 (LUBRICATION SYSTEM)
ENGINE OIL PRESSURE
REGULATOR
The engine oil pressure regulator is located near
exhaust pipe bracket.

1. Engine oil pressure regulator

Removal
Remove the plug screw no. 7, sealing ring no. 8,
compression spring no. 9 and piston no. 10.
Inspection
Inspect piston for scoring or other damages.
Check compression spring for free length, square-
ness or other damage.
SERVICE LIMIT
Installation
For installation, reverse the removal procedure.
NOTE: Always install a new sealing ring when the
oil pressure regulator is removed.
http://ReadManuals.com
Section 03 ENGINE
COMPRESION SPRING FREE LENGTH
42 mm (1.65 in)
03-08-3