System Settings - AMX Enova DVX-3150HD-SP Instruction Manual

To hear only the microphone on an analog output, set the Input mix level all the way down (-100) and the Mic mix level all

the way up.
7. To hear the microphone on an HDMI output, follow the instructions for Mixing Microphones onto Analog and HDMI
Outputs section on page 67 and select an analog output that has been mixed to receive microphone audio in step 6 above.

System Settings

FIG. 70 displays the System page. The System page allows you to switch any audio or video input to any output, set the front panel
button lockout, adjust front panel LED and LCD intensity, and view the device information for the switcher.
1
2
WebConsole Configuration Page - System Page
FIG. 70
1 - Input/Output Matrix: Select an option button under each output to switch video or audio from the corresponding input to
that particular output. Green text indicates a signal is detected, gray indicates a signal is detected but cannot be identified, and
red indicates no signal is detected. You can only select one video and audio input at a time per output. Select None if you do not
want any video or audio on the selected output.
2 - Save/Load: Click the buttons to save or load your DVX settings. Files are saved as an .xdv file to any local or network drive of
your specification.
NOTE: Due to the way many browsers manage f ile upload requests while in an authenticated session, it is not possible to
load a DVX setup (.xdv) f ile with any web browser AMX has tested, except Microsoft Internet Explorer when HTTP Security
is enabled on the DVX Master.
3 - Microphone Mode: Click the checkboxes to activate or deactivate the microphones connected to Mic Inputs 1 and 2 when in
Dual Mode, or the L/R Microphone when in Single Stereo Mode.
4 - Front Panel Lockout Mode: Click the check box to activate a lockout of some or all of the buttons on the front panel. Select
the type of lockout in the Lockout Mode section. Select Full Lockout if you want the lockout to block the use of all front panel
buttons. Select Menu-only Lockout if you want the lockout to only block the use of the menu options on the front panel. The
Switch, Take, Status, Volume, and Mute buttons are still available with this option.
5 - Front Panel Backlight: Use the sliders to adjust the backlight intensity of the LCD display and the LEDs on front panel
buttons. You can set the backlight intensity for each option between 0 and 100. The default setting for each option is 50.
6 - DXLink Ethernet: Use the menu to select the DXLink Input or the DXLink Output, then click the Auto check box to enter Auto
mode for the selected input or output. In Auto mode, Ethernet traffic is enabled if the port is connected to an end-point
transmitter or receiver, but is automatically disabled if connected to a port on another Enova DVX or DGX. When Auto is not
checked, Ethernet is turned off for the selected port.
7 - System Information: This area provides the following read-only information about your unit:
Serial number
MAC Address
IP Hostname
IP Address
IP Subnet Mask
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
3
IP Gateway
IP DNS Addresses
Switcher Firmware Version
Master Firmware Version
Device Firmware Version
Audio/Video Configuration
4
5
6
7
Temperature (ºC)
Temperature Alarm
Fan Speeds (RPMs)
Fan Alarm
Standby Mode
68