Channel Video Switching; Standby Mode - AMX Enova DVX-3150HD-SP Instruction Manual

All-in-one presentation switchers
Hide thumbs Also See for Enova DVX-3150HD-SP:
Table of Contents

Advertisement

DVX-21xx NetLinx Channels
141
1-6
142
1-6
143
1-6
144
1-6
148
1-6
149
1-6
150
1-6
151
1-6
152
1-6
153
1-6
156
1-6
157
1-6
158
1-2
159
1-2
164
1-3
165
1-3
196
1-3
199
1-3
210
1-3
213
1-2
216
1
217
1
234
1-2

Channel Video Switching

To switch video via channels, the channel must be turned ON (as opposed to pulsing the channel).
For example, turn on Channel 31 on Port 1 for Input 1 to output video.
The DVX-315x video channels are 31-40 (Ports 1-4) - see DVX-315x NetLinx Channels on page 74

The DVX-21xx video channels are 31-36 (Ports 1-3) - see DVX-21xx NetLinx Channels on page 75

These channels are mutually exclusive:
Turning On another channel will change input and turn off the last channel.

Turning Off a selected channel will select input none.

Pulsing any channel will set input to none as it turns on, and then back off the channel pulsed.


Standby Mode

Standby Mode can be activated via channel 100 on the DVX. The following points apply to Standby Mode on the DVX:
After exiting Standby Mode, the DVX cannot re-enter Standby Mode for a period of 20 seconds. Any attempt to re-enter

standby mode within this 20 second window is ignored.
When the DVX enters Standby Mode, all video and audio circuitry are turned off. The DVX does not produce a video or audio

output signal in low power state.
The 5002 Device stays online when Standby Mode is active.

All switch and configuration commands sent while in Standby Mode are implemented, and any changes will be noticed after

the DVX exits Standby Mode.
All audio and video signals are restored in less than 10 seconds after exiting Standby Mode.

The DVX exits Standby Mode on any power cycle or reboot.

Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Audio Input Gain Down
Black and White State
Audio Input Gain Mute (Reserved for future use)
Audio Input Gain Mute Cycle (Reserved for future use)
Video In Brightness Ramp Up (only applicable when routed to a scaled output)
Video In Brightness Ramp Down (only applicable when routed to a scaled output)
Video In Saturation Ramp Up (only applicable when routed to a scaled output)
Video In Saturation Ramp Down (only applicable when routed to a scaled output)
Video In Contrast Ramp Up (only applicable when routed to a scaled output)
Video In Contrast Ramp Down (only applicable when routed to a scaled output)
Video In Hue Ramp Up (only applicable when routed to a scaled output)
Video In Hue Ramp Down (only applicable when routed to a scaled output)
Output Zoom Ramp Up
Output Zoom Ramp Down
Audio Output Balance Ramp Left (output 1 is only applicable on -SP units)
Audio Output Balance Ramp Right (output 1 is only applicable on -SP units)
Source Cycle
Volume Mute Set and State
Video Mute Set and State
Video Freeze Set and State
Fan Alarm (read-only channel)
Temperature Alarm (read-only channel)
OSD State
Programming
76

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents