Connecting Piping On The Indoor Unit; Figure 5-29 Removing The Chassis Cover From Indoor Unit - Emerson Liebert SRC18 User Manual

Piping
5.3.7

Connecting Piping on the Indoor Unit

While following this procedure, refer to 5.3.2.1 - Pipe bundling for specific bundling instructions, and to
5.3.3 - Routing the Drain Hose for Indoor Unit for proper drainage slope during piping.
1. Pull the screw cap at the bottom of the indoor unit.
2. Unscrew the 3 screws at the bottom of the chassis cover, Figure 5-29, and remove the chassis cover,
taking care not to scratch the main horizontal vane.

Figure 5-29 Removing the chassis cover from indoor unit

Chassis cover
®
59 Liebert SRC™ User Manual