Setting The Address Of Central Control; Setting E.s.p - Emerson Liebert SRC18 User Manual

2. Press .
The test run starts.
• During the test run, pressing any of the following buttons will exit the test: Oper Mode, Temp
up/down, Fan Speed, Wind Direction, or Start/Stop.

7.3 Setting the Address of Central Control

Refer to Table 7-1 for the specific function-setting values.
1. On the thermostat, press
The function code blinks in the lower-middle of the display.
NOTE
A press less than 3 seconds enters "user" settings mode.
2. Press repeatedly to select the function code.
3. Press , to select the Group No., then use
4. Press , to select the Indoor No., then use
5. Press .
The setting is saved.
6. Press to exit installer setting mode.
NOTE
If there is no button input for 25 seconds, set-up mode is automatically exited.
If you exit without pressing

7.4 Setting E.S.P.

This function determines the wind-strength for each wind level.
Refer to Table 7-1 for the specific function-setting values.
NOTE
If E.S.P is set incorrectly, the unit may malfunction.
ESP may not work on products that do not have "weak" or power fan-speed
settings.
1. On the thermostat, press
The function code blinks in the lower-middle of the display.
NOTE
A press less than 3 seconds enters "user" settings mode.
2. Press repeatedly to select the function code.
3. Press to select the Step (wind level).
4. Press to select the Value (wind strength), then use
for at least 3 seconds.
to select the setting.
to select the setting.
, your settings are not saved.
for at least 3 seconds.
87
Installation Set-up and System Start-up
to select the setting.
®
Liebert SRC™ User Manual