Installation Set-Up And System Start-Up; Accessing Installer Set-Up Mode; Table 7-1: General Unit Functions-Installer Set-Up Codes - Emerson Liebert SRC18 User Manual

7.0 Installation Set-up and System Start-up

NOTICE
Risk of improper thermostat installation. Can cause unit malfunction.
The Installer setting mode sets up the detailed function of the thermostat.
If the installation is not set correctly, it can cause problems for the product, user injury, or property
damage. Installation set-up must be performed by a certified technician. Non-certified personnel
attempting to install or make changes shall be responsible for any adverse effects or operation.

7.1 Accessing Installer Set-up Mode

1. On the thermostat, press
The function code displays.
NOTE
A press less than 3 seconds enters "user" settings mode.
2. Refer to the following procedures and Table 7-1 to make the correct settings for your installation.
NOTE
Some menu options and functions may not be displayed or the menu name
may be different depending on your system and model.
Function
Code
01
02
03
04
05
06
Some menu options and functions may not be displayed or the menu name may be different
depending on your system and model.
for at least 3 seconds.
Table 7-1 General unit functions—Installer set-up codes
Description
Test Run 01 = Set
Address Setting 00 ~ FF = Address
Step:
01 = Very Low
02 = Low
03 = Med
E.S.P Value
04 = High
05 = Very High
Value:
0 ~ 255
01 = Remo
Thermistor 02 = Indoor
03 = 2TH
01 = Low
02 = Med
Ceiling Height
03 = High
04 = Very High
01 = V-H
02 = F-H
Static Pressure
03 = V-L
04 = F-L
Installation Set-up and System Start-up
Value
85
®
Liebert SRC™ User Manual