Mitsubishi ASX Manual page 191

CAUTION
ard brake system is working. (The stand-
ard brake system is functioning normal-
ly.) If this happens, we recommend you to
have your vehicle inspected as soon as pos-
sible.
• When the ignition switch is turned to
the "ON" position or the operation
mode is put in ON, the warning lamp
does not come on or it remains on and
does not go off.
• The warning lamp comes on while driv-
ing
• The warning display appears while
driving
If the warning lamp/display illuminate
while driving
E00607301295
If only the ABS warning lamp/display illuminate
Avoid hard braking and high-speed driving. Stop
the vehicle in a safe place.
Restart the engine and check to see whether the
lamp goes out after a few minutes driving; if it then
remains off during driving, there is no problem.
However, if the warning lamp/display do not disap-
pear, or if they come on again when the vehicle is
driven, we recommend you to have the vehicle
checked.
If the ABS warning lamp/display and brake warn-
ing lamp/display illuminate at the same time
Warning lamp
Warning display type 1
Warning display type 2
The ABS and brake force distribution function may
not work, so hard braking could make the vehicle
unstable.
Avoid hard braking and high-speed driving. Stop
the vehicle in a safe place and we recommend you
to have it checked.
Starting and driving
NOTE
l
The ABS warning lamp and brake warning
lamp illuminate at the same time and the warn-
ing displays appear alternately on the infor-
mation screen in the multi-information dis-
play.
After driving on icy roads
E00618800150
After driving on snow or icy roads, remove any
snow and ice which may have accumulated around
the wheels. On vehicles that have an ABS, be care-
ful not to damage the wheel speed sensors (A) or
the cables located at each wheel.
Front
Rear
4
4-39