Mitsubishi ASX Manual page 253

5. When the disabling of the password is
completed, the voice guide will say "Pass-
word is disabled" and the system will re-
turn to the main menu.
Speaker enrollment function
E00727400238
®
The Bluetooth 2.0 interface can use the speaker en-
rollment function to create a voice model for one
person per language.
®
This makes it easier for the Bluetooth 2.0 inter-
face to recognise voice commands said by you.
You can turn a voice model registered with the
speaker enrollment function on and off whenever
you want.
Speaker enrollment
E00727500200
It takes about 2 to 3 minutes to complete the speak-
er enrollment process.
To ensure the best results, run through the process
while in the driver's seat, in an environment that is
as quiet as possible (when there is no rain or strong
winds and the vehicle windows are closed). Please
turn off your phone while in speaker enrollment to
prevent interruption of the process.
Use the following procedure for speaker enrollment.
1. Stop your vehicle in a safe area, put the gear-
shift lever in the "N" (Neutral) position
(M/T), or the selector lever in the "P"
(PARK) position (CVT), and pull the park-
ing brake lever.
NOTE
l Speaker enrollment is not possible unless the
vehicle is parked. Make sure you park the ve-
hicle in a safe area before attempting speaker
enrollment.
2. Press the SPEECH button.
3. Say "Voice training".
4. The voice guide will say "This operation
must be performed in a quiet environment
while the vehicle is stopped. See the owner's
manual for the list of required training phra-
ses. Press and release the SPEECH button
when you are ready to begin. Press the HANG-
UP button to cancel at any time".
Press the SPEECH button to start the speaker
enrollment process.
NOTE
l If you do not start the speaker enrollment proc-
ess within 3 minutes of pressing the
SPEECH button, the speaker enrollment func-
tion will time out.
The voice guide will say "Speaker Enroll-
ment has timed out". The system will then
beep and the voice recognition mode will be
deactivated.
5. The voice guide will prompt for phrase 1. Re-
peat the corresponding phrase listed in table
"Enrollment commands" on page 5-56.
The system will register your voice and then
move on to the registration of the next com-
mand. Continue the process until all phrases
have been registered.
NOTE
l To repeat the most recent voice training com-
mand, press and release the SPEECH button.
l
If you press the HANG-UP button anytime
during the process, the system will beep and
stop the speaker enrollment process.
For pleasant driving
6. When all enrollment commands have been
read out, the voice guide will say "Speaker
enrollment is complete".
The system will then end the speaker enroll-
ment process and return to the main menu.
NOTE
l Completing the speaker enrollment process
will turn on the voice model automatically.
l
The commands "Help" and "Cancel" will not
work in this mode.
Enabling and disabling the voice model and re-
training
E00727600100
You can turn a voice model registered with the
speaker enrollment function on and off whenever
you want.
You can also retrain the system.
Use the following procedure to perform these ac-
tions.
1. Press the SPEECH button.
2. Say "Voice training".
3. If you have completed a speaker enrollment
process once already, the voice guide will
say either "Enrollment is enabled. Would
you like to disable or retrain?" or "Enroll-
ment is disabled. Would you like to enable
or retrain?"
4. When enrollment is "enabled", the voice mod-
el is on; when enrollment is "disabled", the
voice model is off. Say the command that
fits your needs.
Say "Retrain" to start the speaker enrollment
process and recreate a new voice model. (Re-
fer to "Speaker enrollment" on page 5-45.)
5
5-45