Mitsubishi ASX Manual page 226

For pleasant driving
1. Press the PWR switch to turn the audio sys-
tem ON and OFF. The audio system turns on
in the last mode used.
2. Press the CD button to enter CD mode.
The CD changer will start playback if the
CD is already in the CD changer.
3. To stop the CD, turn off the power by press-
ing the PWR switch, or change over to the ra-
dio mode by pressing the AM/FM button, or
eject the disc by pressing the eject button.
NOTE
l For information on adjusting the volume and
tone, refer to "To adjust the volume" on page
5-11 and "To adjust the tone" on page 5-11.
l As many as 6 CDs can be inserted into the
CD changer.
l 8 cm CDs cannot be played on this CD chang-
er.
l For information concerning the handling of
compact discs, refer to "Handling of compact
discs" on page 5-38.
5
To set a single disc
1. Press the LOAD button briefly.
2. The CD changer will show "WAIT" on the
display and start making itself ready for disc
loading.
3. When the CD changer is ready for disc load-
ing, the LOAD indicator will illuminate and
the display will show "LOAD DISC No.
(1-6)".
4. When a disc is inserted into the CD slot, the
disc will begin to play.
5-18
NOTE
l
If there are multiple empty slots, you can se-
lect your desired slot by pressing the DISC
buttons.
l If you do not insert a disc for about 15 sec-
onds after the CD changer starts standing by
for loading, the loading standby mode will
be cancelled.
To set all the discs
1. Press the LOAD button for 2 seconds or lon-
ger (until you hear a beep).
2. The CD changer will select the lowest-num-
bered empty slot and switch to loading stand-
by mode.
3. When the display shows "LOAD DISC No.
(1-6)" insert a disc. The CD changer will
then automatically select the next empty slot
and enter loading standby mode.
4. Repeat the above-described steps until every
slot contains a disc. Playback will then begin
with the disc that you inserted last.
NOTE
l If you press the LOAD button again while
the CD changer is in loading standby mode,
the loading standby mode will be cancelled.
To select a desired disc
You can select your desired disc by using the DISC
button. The active disc will be indicated on the dis-
play.
<Disc up>
Press the DISC (Disc up) button repeatedly until
the desired disc number appears on the display.
<Disc down>
Press the DISC (Disc down) button repeatedly until
the desired disc number appears on the display.
To listen to a music CD
Push the CD button if a disc is already in the audio
system. The audio system will enter CD mode and
start playback. The disc number (if the audio sys-
tem is equipped with the CD changer), the track
number, and the playing time will appear on the dis-
play. The discs in the CD changer unit will be
played consecutively and continuously.