Auto Stop & Go (As&G) System - Mitsubishi ASX Manual

Turbocharger
The turbocharger increases engine power by push-
ing large amounts of air into the engine's cylinders.
The finned parts inside the turbocharger turn at ex-
tremely high speeds and are subjected to extremely
high temperatures. They are lubricated and cooled
by engine oil. If the engine oil is not replaced at the
specified intervals, the bearings may seize or emit
abnormal noise.
1- Air compressor
2- Compressed air
3- Cylinder
4- Turbo fin
5- Turbine
6- Exhaust gas
Auto Stop & Go (AS&G) system*
E00627400035
The Auto Stop & Go (AS&G) system automatical-
ly stops and restarts the engine without operating
the ignition switch or the engine switch when the
vehicle is stopped, such as at a traffic light or in a
traffic jam, to reduce exhaust gases and increase
fuel efficiency.
CAUTION
l If the vehicle will be stopped for a long
time or if you will leave the vehicle unat-
tended, turn the ignition switch to the
"LOCK" position and press the engine
switch to stop the engine.
Automatically stopping the engine
E00627500036
The Auto Stop & Go (AS&G) system is automati-
cally activated when the ignition switch is turned to
the "ON" position or the operation mode is put in
ON.
You can deactivate the system by pressing the "Au-
to Stop & Go (AS&G) OFF" switch.
Refer to "To deactivate" on page 4-20.
1. Stop the vehicle.
Starting and driving
While depressing the brake pedal, fully de-
press the clutch pedal and place the gearshift
lever in the "N" (Neutral) position.
Vehicles with 5M/T
Vehicles with 6M/T
2. Release the clutch pedal. The " " display/in-
dicator will turn on and the engine will stop
automatically.
4-17
4