Overview; Precautions - Epson Stylus Photo RX700 Service Manual

EPSON Stylus Photo RX900

4.1 Overview

This section describes procedures for disassembling the main components of the
product.
Unless otherwise specified, disassembled units or components can be reassembled by
reversing the disassembly procedure.

4.1.1 Precautions

See the precautions given under the heading "WARNING" and "CAUTION" in the
following column when disassembling or assembling the product.
Things, if not strictly observed, that could result in injury or loss of life are described
under the heading "Warning".
Precautions for any disassembly or assembly procedures are described under the
heading "CAUTION".
Chips for disassembling procedures are described under the heading "CHECK
POINT".
If the assembling procedure is different from the reversed procedure of the
disassembling, the procedure is described under the heading "REASSEMBLY".
Any adjustments required after disassembling the units are described under the heading
"ADJUSTMENT REQUIRED".
When you have to remove any units or parts that are not described in this chapter, refer
to the exploded diagrams in the appendix.
Read precautions described in the next section before starting.
Disassembly and Assembly
W A R N I N G Remove the batteries and plug off the AC adapter before
disassembling the Stylus Photo RX700.
Always wear gloves for disassembly and reassembly to avoid
injury from sharp metal edges.
Lithium batteries are installed on the main board of this
product. Never fail to observe the following instructions when
serving the batteries:
1. Keep each battery away from any metal or other batteries so
that electrodes of the opposite polarity do not come in contact
with each other.
2. Do not heat the battery or put it near fire.
3. Do not solder on any part of the battery. (Doing so may result
in leakage of electrolyte from the battery, burning or
explosion. The leakage may affect other devices close to the
battery.)
4. Do not dismantle the battery. (The gas inside the battery may
hurt your throat. Leakage, burning or explosion may also be
caused.)
5. Do not install the battery in the wrong direction. (This may
cause burning or explosion.)
6. Dispose the used batteries according to government's law and
regulations.
7. To avoid dust explosion or ignition, never heat batteries or
bring them close to flames or throw them into fire.
To protect sensitive microprocessors and circuitry, use static
discharge equipment, such as anti-static wrist straps, when
accessing internal components.
Overview
Revision A
77