Installing A Hot-Plug Pci Adapter (Slots 3 Through 6) - IBM eServer 250 xSeries User Reference Manual

Installing a hot-plug PCI adapter (slots 3 through 6)

Refer to the following illustration to install a hot-plug PCI adapter.
Adapter retention latch
To install a hot-plug PCI adapter:
Attention:
• Do not remove a hot-plug adapter before performing the operating-system-
defined procedure for disabling the hot-plug PCI slot that contains the adapter.
Failure to do so might cause your system to lock up. Refer to your operating
system documentation.
• When you handle static-sensitive devices, take precautions to avoid damage from
static electricity. For details on handling these devices, see "Handling static-
sensitive devices" on page 37.
1. Review the information in"Before you begin" on page 36 through "Safety
information statements" on page 38.
2. Remove the top cover (see "Removing the server top cover and bezel" on page
40).
3. Determine which expansion slot you will use for the adapter.
Note: You can install hot-plug PCI adapters in PCI slots 3 through 6 only.
4. Disable the selected PCI slot from your operating system. (Refer to the
documentation that comes with your operating system for information about
disabling a hot-plug PCI slot.) Disabling the PCI slot turns off the power light for
that PCI slot.
Attention: Make sure that the power light for the hot-plug PCI slot is off before
you continue with the next step.
Adapter
retention latch
Adapter Tab
Chapter 5. Installing options
43