Installation Overview - Motorola DCT6200 Installation Manual

3-2 Installation

Installation Overview

CAUTION!
Be sure to advise the subscriber that, to prevent overheating:
!
Position the DCT* with at least 2 inches of space above and on all sides
!
Do not block the slots and openings in the DCT*
!
Do not place anything on top of the DCT*
!
Do not position the DCT* in an enclosed space that would restrict airflow around the unit
!
Do not position the DCT* near any external heat source that could raise the temperature
around the unit
To install the DCT*:
If an add-on module is required and was not installed previously, install it now.
1
Determine if you are connecting the DCT* to a:
2
High definition TV
(HDTV) or monitor
Standard
definition TV
Determine if you are connecting the audio to a home theater receiver or directly to the TV:
3
If the receiver or TV supports SPDIF, use the coaxial or optical SPDIF audio outputs on
!
the DCT*.
Otherwise, use the baseband left and right
!
Locate the cabling diagram(s) that best match the subscriber configuration.
4
Connect the audio and video cables in a manner matching that diagram.
5
Determine if you are connecting the DCT* to a data device (see "Data Device Connections"
6
in this section). For installation details, refer to instructions included with the data device.
Perform the boot cycle, including the download to the DCT*, as described in "Boot Cycle" in
7
this section.
Perform the operational check for the remote control.
8
Optimize the high definition settings. See "Optimizing the High Definition Settings" in this
9
section.
Verify that the appropriate configuration information has been downloaded using the
10
addressable controller, such as the DAC 6000.
DCT6200\DCT6208 Installation Manual
Use the component video (Y, Pb, and Pr), DVI, or IEEE 1394 outputs. No other
video connection supports HDTV.
Connect the composite
VIDEO
or
Connect the /
RF TO TV VCR
connectors
or
Connect the - connector using a S-video cable
S VIDEO
connector using an RCA phono cable
connector using a 75-ohm coaxial cable with F-type
connectors.
AUDIO OUT