Freset Clear Selected Data From Nvm And Reset; Freset Target - Novatel GNSS Receiver and Antenna SMART-AG User Manual

Appendix B
B.2 FRESET Clear Selected Data from NVM and Reset
The OEMV freset command is extended to include SMART-AG features. An additional target field,
userdata (value = 10), resets only the SMART-AG user data NVM, thereby resetting all parameters
indicated in this document as "Stored in NVM" to factory defaults. Issuing the freset command with
the "target" field set to standard, resets the userdata NVM as well as OEMV parameters as indicated
in the OEMV Family Firmware Reference Manual.
If you issue the FRESET command without any parameters, it is the same as issuing a FRESET
STANDARD command.
Field ASCII
Field
Type Value
1 FRESET -
header
2 target See Table 11
Binary ASCII
0 STANDARD
1 COMMAND
2 GPSALMANAC
3 GPSEPHEM
4 GLOEPHEM
5 MODEL
10 USERDATA
11 CLKCALIBRATION
20 SBASALMANAC
21 LAST_POSITION
31 GLOALMANAC
58
Binary
Description
Value
- This field contains the command name
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary, respectively.
Data to be reset by the receiver
Table 11: FRESET Target
Resets commands, ephemeris, and almanac (default). Also resets all L-
band related data except for subscription information.
Resets the stored commands (saved configuration)
Resets the stored GPS almanac
Resets the stored GPS ephemeris
Resets the stored GLONASS ephemeris
Resets the currently selected model
Reset SMART-AG-only commands
Resets the parameters entered using the CLOCKCALIBRATE command
Resets the stored SBAS almanac
Resets the position using the last stored position
Resets the stored GLONASS almanac
Binary
Format
-
Enum
Description
SMART-AG User Manual Rev 2
Commands
Binary Binary
Bytes Offset
H 0
4 H