Transmitting And Receiving Corrections - Novatel GNSS Receiver and Antenna SMART-AG User Manual

Operation
and [carriage return] indicates that you should press the <Enter> key.
The above example illustrates command input to the base receiver's COM2 port, which sets the
position of the base station receiver for differential operation. Confirmation that the command was
actually accepted is the appearance of <OK.
If a command is entered incorrectly, the receiver responds with:
<I
NVALID
WARNING!:
3.3

Transmitting and Receiving Corrections

Corrections can be transmitted from a base station to a rover station to improve position accuracy. The
base station is the GNSS receiver, which is acting as the stationary reference. It has a known position
and transmits correction messages to the rover station. The rover station is the GNSS receiver which
does not know its exact position and can be sent correction messages from a base station to calculate
differential GNSS positions. An example of a differential setup is given in Figure 5 on Page 30.
SMART-AG User Manual Rev 2
M
ID
ESSAGE
Ensure the Control Panel's Power Settings on your PC/laptop are not set to go
into Hibernate or Standby modes. Data will be lost if one of these modes occurs
during a logging session.
(or a more detailed message)
Chapter 3
29