Video Standby Mode; Start / End Recording - Kompernass DASHCAM CR 5 A1 Operating Instructions Manual

Video standby mode

In video standby mode, the screen
A – displays the remaining recording time depending on resolution and
available storage space
B – current video resolution
C – symbol to indicate an inserted microSD card
D – battery charge level of the internal battery
E – date display (only when the "Time & date stamp" is activated)
E – time display (only when the "Time & date stamp" is activated)
G – symbol for motion detection (only visible if the function is activated)
H – symbol for a loop recording as well as its length in minutes (here 3 minutes)
I – display for exposure correction
J – symbol for video standby
K – red dot fl ashes during recording
L – symbol for a write-protected fi le

Start / end recording

Press the ▲ button
down the button for fast zoom. You can use the ▼ button
zoom out. Press the
video recording the operating display
again to stop the recording.
If you press the MODE button
and the current recording will be write-protected.
NOTE
► As soon as the camera is connected to the vehicle's power supply, the
recording starts. To stop the recording, press the
CR 5 A1
shows the following overview:
repeatedly as required to zoom into the subject. Hold
/ button to start the video recording. During the
blinks green and red. Press the button
during recording, the
in the same way to
symbol is displayed
/ button .
91
GB