Cleaning; Troubleshooting; Fault Causes And Rectifi Cation - Kompernass DASHCAM CR 5 A1 Operating Instructions Manual

Cleaning

GB

Troubleshooting

Fault causes and rectifi cation
Fault
The camera is not
working with the
built-in battery.
The camera does not
work in the vehicle.
The camera does not
record properly during
the journey.
100
CAUTION
Damage to the device!
► To avoid irreparable damage, ensure that no moisture penetrates the
device during cleaning.
■ Clean the surfaces of the device with a soft, dry cloth. Use a normal commercial
detergent and water to remove stubborn residue. Ensure that no water gets
into the device.
This section contains important information on fault identifi cation and rectifi cation.
Observe the instructions in order to avoid risks and damage.
WARNING
Observe the following safety information to avoid risks and property damage:
► Repairs to electrical devices may only be carried out by specialists trained
by the manufacturer. Improper repairs can cause considerable risks to users
and damage to the device.
The following table will help to identify and rectify minor faults:
Possible cause Rectifi cation
The battery is fl at. Charge the built-in battery from a
The vehicle's
battery is fl at.
The fuse in the
car adapter
is defective.
There is a
problem with the
built-in motion
sensor.
switched-on computer connected to
the connection
or the on-board electrical system of
your vehicle.
Charge the vehicle's battery.
Replace the fuse (see section
Changing the fuse).
Activate the built-in motion sensor
(function "Motion detection" in the setup
menu) only while the vehicle is parked.
Increase the sensitivity of the motion
sensor.
on the device,
CR 5 A1