Mounting The Camera On The Windscreen; Providing Electric Power - Kompernass DASHCAM CR 5 A1 Operating Instructions Manual

Mounting the camera on the windscreen

1) To increase the protection for the camera,
you can place the camera in the protective
housing
the camera clicks into place.
2) Screw the cradle
camera Position the suction cup on the wind-
screen. Ensure that the suction cup is pressed
on fl at.
3) Place the suction cup fi rmly against the wind-
screen and press the suction cup locking
lever downwards towards the windscreen.
This creates suction, and the suction cup is
pulled tightly against the windscreen. Pull the
locking lever
release the suction cup from the windscreen.
4) After attaching the camera with the suction
cup on the windscreen, loosen screws A–C
and adjust the camera as per your wishes.
5) Once you have found the desired position and orientation, retighten the knurled
screws
CAUTION
► The camera must be positioned so that the driver's fi eld of vision is not
obscured.

Providing electric power

CAUTION
► Use only the supplied car adapter to power your device.
1) Connect the car adapter
lighter). The operating light
readiness when the socket is live.
2) Connect the supplied USB cable
and the USB socket
on-board power supply, the video recording starts and the operating display
fl ashes alternately red and green. Once the internal backup battery is charging,
the battery charger symbol
CR 5 A1
and push it gently into place until
into the thread of the
in the opposite direction to
.
to your vehicle's on-board power supply (cigarette
on the car adapter
of the camera. As soon as the camera is powered by the
indicates operational
to the USB port on the car adapter
appears on the screen .
87
GB