Handling And Operation; Switching On And Off , Making Settings; Basic Settings; Setup Menu - Kompernass DASHCAM CR 5 A1 Operating Instructions Manual

GB

Handling and operation

Switching on and off , making settings

Basic settings

Setup menu

88
CAUTION
► In vehicles in which the cigarette lighter also works with the ignition switched
off , the device must be disconnected from the cigarette lighter socket after
use. Otherwise, the vehicle battery may be discharged over a long period
of time, since the device also uses power when it is idle. The vehicle's
engine will no longer start.
► In vehicles in which the cigarette lighter is not switched off , the recording is
not interrupted. In this case, you will need to switch off the camera manually.
In this chapter you will receive important information for the handling and operation
of the device.
Press the on/off button to switch on the device. The camera image is displayed
on the screen and the operating display
in video standby mode.
To switch off the device, press and hold the on/off button
To make the basic settings for the device in the setup menu, press the MENU
button followed by the MODE button
Using the ▲▼ buttons
and then call up this menu item with the
menu item without making a change, press the MODE button
the current menu board as well as the total number of menu boards is shown.
To close the menu, press the MENU button
lights up green. The device is now
. The setup menu opens:
/ you can move the selection bar to the desired entry
/
.
for 3 seconds.
Default settings
button . To exit the activated
. Below right,
CR 5 A1