Mounting The Camera On The Windscreen; Providing Electric Power - Kompernass CR 5 A2 Operating Instructions Manual

Mounting the camera on the windscreen

1) Screw the cradle
the camera Position the suction cup on the
windscreen . Ensure that the suction cup is
pressed on flat .
2) Place the suction cup firmly against the wind-
screen and press the suction cup locking
lever downwards towards the windscreen .
This creates suction, and the suction cup is
pulled tightly against the windscreen . Pull the
locking lever
release the suction cup from the windscreen .
The suction cup has a tab at the side, which
makes it easier to remove .
3) After attaching the camera with the suction
cup on the windscreen, loosen the knurled
screws and adjust the camera as per your
wishes .
4) Once you have found the desired position and orientation, retighten the knurled
screws .
CAUTION
► The camera must be positioned so that the driver's field of vision is not
obscured .
► Ensure that the suction cup does not extend more than 4 cm into the wiping
range of the windscreen wipers (light grey area), and that not more than 1 cm
of it is installed in the area directly above the steering wheel (grey area) (see
diagram) .

Providing electric power

CAUTION
► Use only the supplied car adapter to power your device .
1) Connect the car adapter
lighter) . The operating light
readiness when the socket is live .
■ 10 │ GB │ IE
into the thread
in the opposite direction to
to your vehicle's on-board power supply (cigarette
on the car adapter
of
indicates operational
CR 5 A2