Table of Contents
Advertisement
4.
Once the Decoders and displays are connected and powered up, the LocalPlay screen appears on the displays.
NOTE: If the LocalPlay screen does not appear, refer to Chapter 5, Troubleshooting for more guidance.
NOTE: In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE (Power Sourcing
Equipment) port. The N2212 Decoder is not a PoE device. When using this product, you must also provide power using the 12V
external power supply (included in shipment). PoE does not pass through the daisy chain (P1) port.
CAUTION:
use only.
Step 3: Connecting Encoders to the Network and Conf iguring Stream
Settings
1.
Using a Cat-5 cable, connect your SVSI Encoder's P0 port to a PoE-enabled switch. In non-PoE applications connect a 12V
regulated power supply (N9312) to the two-pin terminal block plug connector (labeled +12V 2A).
NOTE: In order for the unit to receive PoE, it must be connected to a switch or other equipment that has a PoE PSE port.
2.
In N-Able, select the Unit Management tab and click the Auto Discover button (if the table has not already populated itself
with the installed units). See
Unit Management Page
FIG. 6
3.
Find your Encoder in the list. N2000 units are displayed on the following tabs:
• Unit Management tab — N2000 units have N2000 Encoder/Decoder listed in their Type fields.
• Video Matrix tab — N2000 units are found on the N2000 sub-tab (as shown in
NOTE: If using multiple Encoders in your set up, it is important to plug in and conf igure one Encoder at a time. All Encoders come pre-
conf igured to use stream 1. As you add Encoders to the network, you will need to set them up to use different streams.
N2000 Series User Manual
Do not run wiring that is connected to a PoE PSE port outside of the building where the PSE resides. It is for intra-building
Figure
6.
Installing and Configuring Your AV Equipment
Figure
7).
19
Advertisement
Table of Contents
