AMX NMX-ENC-N2122, NMX-DEC-N2222, NMX-DEC-N2212, NMX-ENC-N2135, AND NMX-DEC-N2235 Instruction Manual page 18

Svsi n2000 series encoders/decoders digital media distribution & switching solution

Table of Contents

Enable the Use the following IP

address option, and enter the

static IP address provided to you

by your network administrator.

NOTE: If the computer does not need Internet access, you can simply enter a unique 169.254.xxx.xxx IP address with a 255.255.0.0

subnet mask. Contact your network administrator if you are unsure of how to conf igure the existing network. SVSI units will not self-

assign in the 169.254.0.xxx range.

NOTE: If the computer has a statically-assigned IP address, click the Advanced button. Then click Add to enter a unique

169.254.xxx.xxx address with a Subnet Mask of 255.255.0.0 and a Default Gateway of 169.254.1.1.

Step 2: Connecting Decoders to the Network

The digital connection from a Decoder HDMI OUT port (female) to a display is accomplished using either a HDMI cable or DVI-D

(through adapter). N2000 units support embedded audio input and output on the HDMI ports; however, some display devices (e.g.,

many monitors) do not support embedded audio. When using such a display, use the AUDIO port for separate transmission of

sound and turn HDMI Audio off (on the Settings page) to avoid video display issues.

Power is supplied via a PoE-enabled switch or an external power supply. The N2212 is not a PoE device and must be powered by an

external power supply. Refer to the following steps and

Using a Cat-5 cable, connect your SVSI Decoder's P0 port to a PoE-enabled switch. This provides both network and power

connection. In non-PoE applications connect a 12V regulated power supply (N9312) to the two-pin terminal block plug

connector (labeled +12V 2A).

Connect the display you would like to use for that Decoder (monitor, projector, etc.) to the Decoder's HDMI OUT port using an

HDMI cable (or DVI through adapter). This must be a digital video connection.

Decoder Connections

FIG. 5

Repeat Steps 1 and 2 until all Decoders are installed on the network.

N2000 Series User Manual

Figure 5

for guidance.

N2000 Decoder

Cat-5 Cable

PoE-Enabled Switch

Installing and Configuring Your AV Equipment

HDMI Cable

Network

Table of Contents