Connection Of Wrist Strap For Esd - Nortel DCT1900 Technical Product Manual

4.10

Connection of Wrist Strap for ESD

After mounting the Modular Cabinet(s), the installer has to protect against damaging system
boards by ESD. The installer must use a wrist strap which must be connected to the cabinet at the
connector indicated in Figure 4–2 and Figure 4-3.
Note:
The Modular Cabinet must be connected to protective ground.
Flat Cable
R-network
R201, R202
and R207
R-network
R401, R402
and R407
R-network installed
R-network removed
Fig. 4-9 Example of Interconnecting the System Bus and the Ground Plates
Install-DCT1900/R8/mw
© 2000-2005
Protective Ground Cable
Technical Product Manual - DCT1900
Installation Instructions, or BDVNB 101 01/3
4-11