Auto Sleep - Newland NLS-HR200C User Manual

【Enter Setup】

Auto Sleep

Auto Sleep allows the scanner in the Manual Mode to automatically enter the sleep or low power mode if
no operation or communication is performed for a time period (user programmable). When the scanner is
in the sleep mode, receiving trigger signal or communication from the Host can awake the scanner. The
scanner returns to full operation within 100ms.
**【Enable Auto Sleep】
The parameter below specifies how long the scanner remains idle (no operation or communication occurs)
before it is put into sleep mode. It is programmable in 1ms increments from 0ms to 65,535ms. The default
setting is 500ms.
Set the time period from idle to sleep to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Time Period from Idle to Sleep barcode.
3.
4. Scan the Save barcode. (See the "Save/Cancel Barcodes" section in Appendix)
5. Scan the Exit Setup barcode.
**【Exit Setup】
【Time Period from Idle to Sleep】
Scan the numeric barcodes "1", "5", "0" and "0". (See the "Digit Barcodes"
section in Appendix)
【Disable Auto Sleep】
34