Auto Sleep
Auto Sleep allows the scanner in the Manual mode to automatically enter the light sleep mode if no
operation or communication is performed for a time period (user programmable). When the scanner is in
the light sleep mode, pressing the trigger or receiving command from the host device can awaken the
scanner.
** Enable Auto Sleep
The parameter below specifies how long the scanner remains idle (no operation or communication occurs)
before it is put into the light sleep mode. It is programmable in 1ms increments from 0ms to 6,000ms. The
default setting is 500ms.
Example: Set the time period from idle to sleep to 1000ms
1.
Scan the Enter Setup barcode.
2.
Scan the Time Period from Idle to Sleep barcode.
3.
Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
4.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5.
Scan the Exit Setup barcode.
21
Time Period from Idle to Sleep
** Enter Setup
Disable Auto Sleep
Exit Setup