Table of Contents
Advertisement
7) Install fan shield as shown in Fig. #13. Be sure to place
the air inlet opening against the surround side.
8) Install the cast decorative top by tilting it at a slight angle,
sliding it under the surround top, and settling it over the
fan shields. (Fig #14).
9) Be sure to engage fan shield tops in the slots on the un-
derside of the cast decorative top. (Fig. #15)
Fig. # 13
AIR INLET
SURROUND
SIDE
Fig. # 14
ALT5.CPINSB 080515-24
Fig. # 15
SLOT
Fan Removal/Installation
1) Remove Decorative Top and both Fan shields as specifi ed
in "Fan Speed Control Relocation" section on page 11.
2) Disconnect fan wires as shown in Fig #16 from appropri-
ate fan that is being replaced. Remove Thermal switch if
needed. (Fig #17)
3) Remove the two screws securing the fan bracket to the
stove using a 7/16" socket or wrench. Reverse steps 1&2
to install new fan.(Fig #17)
Fig. # 16
Fig. # 17
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
SCREWS
THERMAL
SWITCH
11
Advertisement
Table of Contents
