Pacific energy Alderlea T5 Classic Insert Installation And Operating Instructions Manual page 13

7) Remove the control assembly from the ashlip bracket on
the right hand side. Flip it over and reattach on the left
hand side of the ashlip (Fig #25). Use the upper screw
holes for best alignment.
Fig. # 25
SPEED CONTROL
8) Route cable from speed control to fan and reattach wire
support tabs on the underside of the ash lip. Note wire
positions.
(Fig.26 & Fig.27)
WIRE SUPPORT TABS
Fig. # 26
Fig. # 27
ALT5.CPINSB 080515-24
9) Reconnect the wires to the fans (Fig.28) and re-attach
ASHLIP BRACKET
Fig. # 28
Fig. # 29
Fig. # 30
thermal snap switch (Fig.29). Refi t ash lip, sides and top.
Ensure that the power cable is correctly routed through the
surround and it is not touching the fi rebox side (Fig #30).
Wire placement is important to prevent damage to wires.
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
THERMAL
SWITCH
13