Table of Contents
Advertisement
Installation and connection
Hot water connection
To keep electricity consumption costs
down this washer-extractor and tumble
dryer stack can be connected to a
(ring) piped hot water supply, max.
temperature 70°C. It is not economical
to run it from an individual hot water
supply if it is not in continuous use, as
the water in the supply pipes cools
down and more energy would be
required to reheat the water. For hot
water connection the same conditions
apply as for cold water connection.
The inlet hose with the red stripes (hot
water hose) is connected to the
stopcock.
For operational reasons the
washer-extractor must not be
connected to hot water only.
If the washer-extractor is not connected
to the hot water connection, the Main
wash water setting must be set
accordingly and the hot water inlet
hose must be detached:
^ Go to the Settings/Supervisor
level/Main wash water and select the
Cold option.
76
The programme durations may be
longer.
^ Unscrew the inlet hose (hot water -
red stripes).
^ Plug the inlet connection with the
blanking cap supplied.
Grey water connection
The washer-extractor can be
connected to a grey water supply.
^ Unscrew the blanking cap from the
grey water valve.
^ Connect the additional inlet hose to
this valve.
The main wash and rinses water
settings must then be set as
appropriate.
^ Go to Settings menu/Supervisor level
menu and select the Grey water
option.
Hot water supply
It is possible to connect the
washer-extractor and tumble dryer
stack to a hot water supply, 70°C to a
maximum of 85°C. A special inlet hose
is required for this option. The machine
must also be reprogrammed by a Miele
service technician or Miele authorised
service dealer.
Hide quick links:
Advertisement
Table of Contents
