Miele PWT 6089 Vario Operating And Installation Instructions page 54

Problem solving guide
Message in the display
p
Water intake fault
Open the stopcock
and
check the inlet hose.
,
Technical fault
,
Fault
Disinfection
temperature
not reached
q
Drain fault
Clean the drainage
system
Fill the container
or
O
Fault
Container empty
A To switch off the fault message, press the multi-function selector.
54
Possible cause
The water inlet is
blocked or restricted.
The water pressure is
too low.
There is a fault.
During the disinfection
programme the water
temperature was not
reached.
The water outlet is
blocked or restricted.
One of the external
detergent containers is
empty.
Remedy A
Check whether
– the stopcock is opened
properly.
– the inlet hose is kinked.
– Select Low water
pressure in the
Settings/Supervisor level
menu.
Start the programme again.
If the fault message appears
again, contact the Service
Department.
The washer-extractor has
not carried out the
disinfection cycle correctly.
Start the programme again.
LP version: Clean the
drainage system.
AV version: Call the Service
Department.
See "Detergent - Empty
sensor".