Miele PWT 6089 Vario Operating And Installation Instructions page 55

Problem
Adjust the load
1
The drum is empty or
the laundry is too dry.
Technical fault
;
If restart is unsuccessful,
call Service.
A fault number (e.g.
F43) might also be
displayed.
Power failure
:
Programme stopped
Press OK button
Clean out airways
E
Clean the filters
Check ducting
appears after a while.*
* You can adjust the setting which controls if or when the check message
appears:
See "Clean the filter" and "Cleaning out airways" in the "Settings/Supervisor level
menu" in the separate booklet "Tumble dryer Commissioning, Programme chart
and Settings" supplied.
Possible cause
This is not a fault.
In some programmes, if
the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can also
happen if the items are
already dry.
A programme cannot be
started while there is a
fault message in the
display.
If the dryer is switched
off during a drying
programme or there has
been a power cut:
Reminder to clean the
filter.
Problem solving guide
Remedy
Use the Hot air
programme (timed
drying) to dry individual
items.
To delete the message:
– Open the door.
– Make a note of what
is shown in the
display.
– Try to start the
programme again.
– When the dryer is
switched on again
and/or the power is
restored, confirm with
OK and start the
programme again.
– Clean the fluff filter.
To delete the message:
– Confirm with OK.
55