Table of Contents
Advertisement
Installation surface
,
Do not install the appliance
stack near or directly above an open
gully or floor drain. Moisture from
these can penetrate the stack and
damage electrical components.
,
Ensure that the feet of the
washer-extractor and the floor are
dry to prevent the washer-extractor
from slipping during the spin cycle.
A concrete floor is the most suitable
installation surface, being far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
^ The appliance stack must be level
and securely positioned.
^ To avoid vibrations during spinning, it
should not be installed on soft floor
coverings.
If installing on a wooden joist floor:
^ We recommend a plywood base (at
least 69 x 77 x 3 cm). The base
should span several joists and be
bolted to the joists and not only to the
floorboards. Check for the presence
of pipes and cables first.
If possible, install the stack in a corner,
as this is usually the most stable part of
the floor.
Installation and connection
Removing the transit bars
^ Release the catch on the
washer-extractor and turn the left
hand transit fitting clockwise by 90°.
^ Then withdraw the transit bar.
69
Hide quick links:
Advertisement
Table of Contents
