Starting A Wash Cycle; Changing A Programme; At The End Of A Programme; Switching Off The Unit - Sandstrom SDW60W10N Instruction Manual

Starting a Wash Cycle

Please follow the steps below to start a wash cycle.
1. Ensure the unit is connected to the mains power and the water supply is on (water pressure between
0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets back. It is
recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
4. Press the ON/OFF button.
5. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
"Wash Cycle Table".
6. The indicator light of the selected programme will illuminate.
7. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not
slam the door.
8. The washing cycle will begin shortly.
If you open the dishwasher door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds. However, if the door is not closed
correctly after 1 minute, the dishwasher will make an audible sound at 1 minute intervals.

Changing a Programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to check if the unit has dispensed the detergent or detergent tablet. This will
depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest that you allow the wash cycle to finish.
3. If the detergent dispenser lid is still closed, press and hold down the programme button for 3 seconds
to cancel the programme. You can then press the required new programme button and close the
dishwasher door. The unit will start the new washing cycle shortly.
4. The display window shows the state of the dishwasher.
a. "-:--" means the unit is on stand by mode.
b. "H:MM" and not flashing means the unit is on pause.
c.
"H:MM" and flashing means the unit is running.

At the End of a Programme

At the end of a programme, the dishwasher will make an audible sound.
The condensation strip helps to prevent the risk of steam damage to the worktop edging above
the dishwasher, it is advisable to leave the door closed until you are ready to unload the crockery.
However, you can also open the dishwasher door fully and wait until the dishes and crockery are
cool enough to unload. Do not leave the door only partially open.

Switching Off the Unit

For energy saving, remember to switch the dishwasher off using the ON/OFF button. The dishwasher will
continue to use electricity until it is switched off with the ON/OFF button.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect the
unit from the mains supply.
SDW60W_X10N_IB_5L_100921.indb 23
GB
23
21/09/2010 5:51 PM