Specification - Sandstrom SDW60W10N Instruction Manual

General problems (continued)
Problem
White residue is visible
on cutlery and crockery,
clouding occurs on
glassware; film can be
wiped off.
Glassware is dull and
GB
discoloured; film cannot be
wiped off.
Tea or lipstick stains have
not been completely
removed.

Specification

Dimensions:
Capacity:
Water Pressure Required:
Power Consumption:
Rated Voltage:
Because we continually strive to improve our products we may change specifications and designs without
prior notice.
28
SDW60W_X10N_IB_5L_100921.indb 28
Possible Causes
Not enough rinse aid was used.
There is not enough salt in the salt
reservoir.
The salt reservoir cap has not
been screwed on correctly.
Unsuitable detergent has been
used.
The salt consumption setting is
too low.
The glassware is not dishwasher
proof. The surfaces are affected.
The wash temperature of the
selected programme was too low.
The bleaching effect of the
detergent used is too low.
Forgot to pre-rinse or remove
the stains with a napkin prior to
washing.
600 (W) x 630 (D) x 820 (H) (mm)
Remedy
Replenish the reservoir, adjust the
rinse aid dispenser dial to a higher
setting or change the brand of rinse
aid.
Fill the salt reservoir.
Ensure that it is screwed back on
correctly.
Change your detergent. Use a
dishwasher standard powder
detergent.
Select a higher salt consumption
setting.
Wash the non-dishwasher proof
glassware by hand.
Select a programme with a higher
wash temperature.
Change your detergent.
Pre-rinse or remove the stains with a
napkin prior to washing.
12 Place Settings
0.04 - 1.00MPa
1930W
230V/50Hz
21/09/2010 5:51 PM