Starting A Wash Cycle; Changing A Programme; At The End Of A Programme - Sandstrom SDWTTB14E Installation Instructions Manual

Starting a Wash Cycle

1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close
firmly afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly.
Do not slam the door.
5. Press the On/Off button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer
to the section Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
Start/Pause button, the washing cycle will begin shortly.
8. Press the
9. The display window shows the state of the dishwasher.
a. "--:--" means the unit is on stand by mode.
b. "H:MM" and not flashing means the unit is on pause.
c. "H:MM" and flashing means the unit is running.
If you open the dishwasher's door during the washing cycle and then close it, the dishwasher will continue
the current washing programme after 10 seconds. However, if the door is not closed correctly after 1 minute,
the dishwasher will beep at 1 minute intervals.

Changing a Programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the
unit has dispensed the detergent or detergent tablet. This will depend on how long the
washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, close the dishwasher door. Press and hold down
the P Programme button for 3 seconds to cancel the programme. Then, press the required
P Programme button and confirm the selection by pressing the
unit will start the new washing cycle shortly.

At the End of a Programme

At the end of the programme, the dishwasher will beep.
The condensation strip helps prevent the risk of steam damage to the worktop edging above the
dishwasher. It is advisable to leave the door closed until you are ready to unload the crockery. Do not leave
the door only partially open. Do not leave the appliance unattended with the door fully open as this could
present a trip hazard.
Start/Pause button. The
GB
33 33