Starting A Wash Cycle - Sandstrom SDW60W14N Installation Instructions Manual

• Express function is available only for intensive, normal, economy, or glass washing cycle.
• Extra drying function is available only for intensive, normal, economy, glass, or 1 hour washing cycle.
• If you choose to use detergent tablet in these washing cycles, please do not add rinse aid.
Condensing dry technology
• Energy is saved by drying the dishes using the remaining heat after the last rinse cycle.
• Wash cycle times are extended due to this drying method.
• Some wash programmes do not have a drying function, please refer to the Wash Cycle Table for more
details.

Starting a Wash Cycle

1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets
back. It is recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close
firmly afterwards.
4. Press the On/Off button.
5. Close the dishwasher door,A click sound should be heard when the door is closed correctly.
Do not slam the door.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer
to the section Wash Cycle Table.
7. Then press the start/pause button, the indicator light of the selected programme will
illuminate.
8. The washing cycle will begin shortly.
• If you open the dishwasher's door during the washing cycle and then close it, the dishwasher will continue
the current washing programme after 10 seconds. However, if the door is not closed correctly after 1
minute, the dishwasher will beep at 1 minute intervals.
• The programme light will blink while the wash cycle is running.
GB
39