Starting A Wash Cycle; Changing Or Cancelling A Programme - Sandstrom SDW60B12 Instruction Manual

Starting a Wash Cycle

1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure
between 0.04MPa and 1.00MPa).
2. Open the door. Pull out the lower and upper baskets, load the dishes and push the baskets back. It is
recommended that the lower basket is loaded first, and then the upper basket.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close firmly
afterwards.
On/Off Mode button.
4. Press the
5. Select the wash cycle programme based on the loading and soil requirements. Please refer to the
section "Wash Cycle Table".
6. The display will indicate the selected programme.
7. If the items are very soiled then pressing the Pre-Wash button (ensure indicator is lit) will provide an
additional pre-wash (using this can increase programme time, energy consumption and water usage).
8. Close the dishwasher door. Do not slam the door.
9. The washing cycle will begin shortly.
If you open the dishwasher's door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds.

Changing or Cancelling a Programme

To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has
dispensed the detergent or detergent tablet. This will depend on how long the washing cycle was
running for. The last selected programme will appear on the window display.
2. If the detergent dispenser lid is opened, we suggest you allow the wash cycle to finish.
3. If the detergent dispenser lid is still closed, press and hold down the Program button for 3 seconds to
cancel the programme. End of program indicator flashes and the display window shows "1". You can
then select the required new programme button and close the dishwasher door. The unit will start the
new washing cycle shortly.
21