Adjusting Rinse Aid Reservoir; Adding Salt - Sandstrom SDW60W10N Instruction Manual

Adjusting Rinse Aid Reservoir

The rinse aid reservoir has six settings. Both the recommended setting
and the factory setting is "4. " If the dishes are not drying properly or are
spotted, adjust the dial to the next higher number until your dishes are
spot-free.

Adding Salt

If the water in your area is hard, deposits will form on your dishes and utensils. As such, this appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and it must be set to correspond to the
water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
GB
Open
Open
Open
2. Fill the reservoir with approximately 500ml of water (first use only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt depending on the brand used.
5. Clean any excess salt from around the reservoir opening and then screw the cap on again firmly.
6. Run the "rapid" wash programme immediately (without any crockery in the dishwasher) to remove any
traces of salt from the compartment.
The salt warning light will illuminate when the reservoir is running out of salt
and requires re-filling. The salt warning light will cease to illuminate within a
1/2
few days depending on how quickly the salt dissolves.
Salt Warning Light
17
SDW60W_X10N_IB_5L_100921.indb 17 21/09/2010 5:51 PM