Sandstrom SDW60W10N Instruction Manual page 9

INSTALLATION
8. Position the dishwasher next to a water tap and a drain. Ensure the water inlet and drain hoses are
not kinked or squashed. The unit must not stand on the mains cable.
9. Make sure your plumbing is suitable for use with the dishwasher. If in doubt contact a qualified
plumber. This unit must be connected to cold water mains using the new water inlet hose. Old hose
sets must not be re-used. The water pressure from the water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
- Connect one end of the safety water supply hose to your dishwasher, and then connect the other
end of the hose to your water mains. Please ensure the black rubber seal is in place.
- After connecting the hose, turn on your water mains and check for leaks.
- Connect the dishwasher to the mains socket.
You may use a Y-adaptor (not included) for additional water feed for another appliance,
for instance a washing machine. This is only applicable for cold water mains. A Y-adaptor is
available from most dry stores.
- Do not bend your drain hose.
SDW60W_X10N_IB_5L_100921.indb 9
Water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
Safety water supply hose
GB
9
21/09/2010 5:50 PM