Troubleshooting Guide; Fault Code; Technical Problems - Sandstrom SDW60W10N Instruction Manual

Troubleshooting Guide

Repairs should only be carried out by a qualified technician in strict accordance with current local
and national safety regulations. Unauthorised or incorrect repairs could cause personal injury or
damage to the unit.

Fault Code

Codes
E1
E4

Technical Problems

Technical problems
Problem
The dishwasher does not
start.
The drain pump is not
working properly.
General problems
Problem
Detergent residue is left in
the dispenser at the end of
the programme.
The detergent dispenser lid
cannot be closed properly.
Knocking noise in the wash
cabinet.
Smearing appears on
glassware and cutlery.
Dishes, cutlery and glasses
are not dry.
SDW60W_X10N_IB_5L_100921.indb 27
Possible Causes
Water tap is not turned on.
Low water pressure (<0.04MPa)
Flow meter is broken.
The wire terminals which connect the flow
meter are loose.
The tank is leaking.
The hose is leaking.
The float switch is broken or PCB is faulty.
Possible Causes
The door is not properly closed.
The unit is not connected to the
mains.
The unit is not switched on.
Fault code E4 - The anti-flooding
system has operated.
Possible Causes
The detergent dispenser was still
damp when detergent was added.
Clogged detergent residue is
blocking the catch.
A spray arm is knocking against
an item in a basket.
The rinse aid dosage is set too
high.
The amount of rinse aid may
be insufficient, or the rinse aid
reservoir is almost empty.
Crockery was taken out of the
dishwasher too soon.
Remedy
Turn on the water tap.
Turn on the water tap and ensure it is in
full position.
• Disconnect from the mains.
• Disconnect the water inlet.
• Call a qualified technician.
Remedy
Close the door firmly.
Connect the plug to the mains.
Press the "on/off " button and select a
programme.
• Disconnect from the mains.
• Disconnect the water inlet.
• Call a qualified technician.
Remedy
Make sure the dispenser is dry before
adding detergent.
Clean the catch.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm. See the
section "loading the dishwasher"
Adjust the dial of the rinse aid
dispenser to a lower setting.
Replenish the reservoir, adjust the
rinse aid dispenser dial to a higher
setting or change the brand of rinse
aid.
Leave the crockery in the dishwasher
until you hear the audible sound.
GB
27
21/09/2010 5:51 PM