Keys; Remote Keyless Entry; Mirrors - Power Electric - Winnebago Via 25Q Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
• Inspect the belts and hardware periodically.
Check for cuts, frays, and loose parts.
Damaged parts should be replaced. Do not
remove or modify the belt system.
• Keep belts clean and dry. If the belts need
cleaning, use only a mild soap and water
solution. Do not use hot water. Do not use
abrasive cleaners, bleach, or dyes. These
products may weaken the belts.
• Replace any belt assembly that was used
during a severe impact. Replace the complete
assembly even if damage is not apparent.

KEYS

Your motorhome is supplied with several
keys. In addition to the chassis manufacturer's
ignition key, you receive keys for the entrance
door and exterior compartment doors.
Keys have an identification number, either a
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle's
component model/serial sheet, which is included
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.

REMOTE KEYLESS ENTRY

The main entry door on your vehicle is
equipped with a Remote Keyless Entry system. If
your coach is featured with a driver door, it also
will be equipped with this system. Use the
provided keyless remote transmitter to lock and
unlock the entry door as well as the driver door (if
equipped).
Make a habit of having the keys with you
when you exit the vehicle and if opening the
driver door (if equipped), first before opening the
entry door whenever unlocking with the keyless
remote.
3-4
MIRRORS – POWER ELECTRIC
–If Equipped
Always adjust mirrors for maximum rear
visibility before driving off. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
Mirror Adjustment Control
The mirror control is located on the driver side
armrest panel or the dash. The ignition key must
be on to adjust the mirrors.
Move Selector Switch L or R to select mirror.
Center "neutral" position disables arrows
to avoid unintentionally moving a mirror.
Press Arrow Buttons to move
mirror surface in direction indicated.
Mirror Heaters
The mirrors may also contain heating
elements to de-fog or de-ice the mirror glass
during cold weather operation. A switch for the
mirror heaters is located on the dash. To turn on,
press the switch UP. Press DOWN to turn off.
Mirror Heat Switch
(Located on dash)
-Typical View