Unit Start-Up - Carrier AQUASNAP 30RAP010-150 Controls, Start-Up, Operation, Service, And Troubleshooting

6. CHILLED WATER PUMP STARTER INTERLOCKED WITH CHILLER.
7. INTEGRATED 40 MESH Y STRAINER CLEAN.
8. WATER LOOP VOLUME GREATER THAN MINIMUM REQUIREMENTS. (See Table 20).
9. PROPER LOOP FREEZE PROTECTION PROVIDED TO _____ °F (°C).
ANTIFREEZE TYPE _____________________ CONCENTRATION __________%.
IF OUTDOOR AMBIENT IS BELOW 32 F (0° C) THEN ITEMS 9-11 HAVE TO BE
COMPLETED TO PROVIDE COOLER FREEZE PROTECTION TO –20 F (–29 C). (REFER
TO WINTER SHUTDOWN FOR PROPER COOLER WINTERIZATION PROCEDURE.)
NOTE: GLYCOL CONCENTRATIONS ABOVE 30% MAY REQUIRE A FLOW SWITCH RE-CALIBRATION.
10. OUTDOOR PIPING WRAPPED WITH ELECTRIC HEATER TAPE,
INSULATED AND OPERATIONAL.
11. COOLER HEATERS INSTALLED AND OPERATIONAL.
12. CHILLED WATER PUMP CONTROLLED BY CHILLER.
13. CRANKCASE HEATERS (IF EQUIPPED) ARE SECURELY ATTACHED, OPERATIONAL,
AND ENERGIZED TO REMOVE ANY LIQUID FROM THE COMPRESSOR.
SIGNATURE REQUIRED
PRELIMINARY START-UP COMPLETE.
INSTALLING/MECHANICAL CONTRACTOR ____________________________________ DATE_________________
III. Unit Start-Up (Qualified individuals only. Factory start-up recommended.)
Design Information
CAPACITY CEAT
1. ALL CABLES AND THERMISTORS HAVE BEEN INSPECTED FOR CROSSED WIRES.
2. ALL THERMISTORS ARE FULLY INSERTED INTO WELLS.
3. COMPRESSOR OIL LEVEL IS CORRECT.
4. VERIFY CRANKCASE HEATERS 9IF EQUIPPED) HAVE BEEN ENERGIZED
FOR 24 HOURS.
5. VERIFY COMPRESSOR MOUNTING BOLT TORQUE IS 7-10 FT-LB. (9.5-13.5 N-M).
6. LEAK CHECK UNIT. LOCATE, REPAIR AND REPORT ANY REFRIGERANT LEAKS.
7. VOLTAGE IS WITHIN UNIT NAMEPLATE RANGE.
8. CONTROL TRANSFORMER PRIMARY CONNECTION SET FOR PROPER VOLTAGE.
9. CONTROL TRANSFORMER SECONDARY VOLTAGE =
EWT LWT FLUID TYPE
CL-2
FLOW RATE P.D.
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO
 
YES NO