Basic Controls Usage; Scrolling Marquee Display; Unit Sizes - Carrier AQUASNAP 30RAP010-150 Controls, Start-Up, Operation, Service, And Troubleshooting

Table 1 — Unit Sizes
UNIT
30RAP010
30RAP015
30RAP018
30RAP020
30RAP025
30RAP030
30RAP035
30RAP040
30RAP045
30RAP050
30RAP055
30RAP060
30RAP070
30RAP080
30RAP090
30RAP100
30RAP115
30RAP130
30RAP150

Basic Controls Usage

SCROLLING MARQUEE DISPLAY — The scrolling mar-
quee display is the standard interface display to the ComfortLink
Control System for 30RAP units. The display has up and down
arrow keys, an key, and an
ENTER
keys are used to navigate through the different levels of the
display structure. Press the
operating level is displayed to move through the top 11 mode
levels indicated by LEDs (light-emitting diodes) on the left side
of the display. See Fig. 1 and Table 2.
Once within a mode or sub-mode, pressing the
and keys simultaneously will put the scrolling
ESCAPE
marquee display into expanded text mode where the full mean-
ing of all sub-modes, items and their values can be displayed
for the current selection. Press the
keys to return the scrolling marquee display to its default menu
of rotating display items (those items in Run Status
In addition, the password will be disabled, requiring that it be
entered again before changes can be made to password protect-
ed items. Press the ESCAPE
text mode.
NOTE: When the Language Selection (Configuration

DISP LANG), variable is changed, all appropriate display
NOMINAL CAPACITY (TONS)
10
14
16
19
24
28
34
39
43
48
52
56
69
77
85
99
112
126
140
ESCAPE key. These
key until the highest
ESCAPE
ENTER
and ESCAPE
ENTER

VIEW).
key to exit out of the expanded
expansions will immediately change to the new language. No
power-off or control reset is required when reconfiguring
languages.
When a specific item is located, the item name alternates
with the value. Press the
and the value will be displayed. Press
value will begin to flash indicating that the value can be
changed. Use the up and down arrow keys to change the value,
and confirm the value by pressing the
MODE
Run Status
Service Test
Temperature
Pressures
Setpoints
Inputs
Outputs
Configuration
Time Clock
Operating Modes
Alarms
Fig. 1 — Scrolling Marquee Display
Changing item values or testing outputs is accomplished in
the same manner. Locate and display the desired item. Press
so that the item value flashes. Use the arrow keys to
ENTER
change the value or state and press the
it. Press the
ESCAPE
structure. Repeat the process as required for other items.
Items in the Configuration and Service Test modes are pass-
word protected. The words 'PASS' and 'WORD' will alternate
on the display when required. The default password is 1111.
Press ENTER and the 1111 password will be displayed. Press
again and the first digit will begin to flash. Use the
ENTER
arrow keys to change the number and press
the digit. Continue with the remaining digits of the password.
The password can only be changed through CCN operator
interface software such as ComfortWORKS
VIEW™ and Service Tool.
Configuration value cannot be changed while the unit is en-
abled. Remote-Off-Enable must be in the off position in order
to change any configuration mode.
See Table 2 and Appendix A for further details. See Table 3

for a description of operating modes.
4
ENTER key at a changeable item
again and the
ENTER
key.
ENTER
Alarm Status
ESCAPE ENTER
key to accept
ENTER
key to return to the next higher level of
ENTER
®
to accept
, Comfort-